Daily Maintenance Of Bending Machine

The steel bar bending machine is suitable for bending processing of steel bars in reinforced concrete structures such as highways, high-speed railways, and large bridges. In order to ensure the performance of the bending machine, it is necessary to do its maintenance and maintenance at ordinary times. Let's talk about the maintenance methods of the steel bending machine.

1. First of all, before turning on the equipment, we should open the accessory box to check whether the accessories are complete, the equipment should be grounded during installation, and the power supply must be equipped with a leakage protector.

2. Check whether all parts are in good condition and whether the bolts are firm.

3. After the machine is used, the stains on the parts must be cleaned up in time to keep the machine clean.

4. After using the machine, be sure to cut off the power supply of the machine.

5. When the steel bar bending machine is cutting the knife or inspecting the machine, be sure to cut off the power supply.

6. Before the equipment is used, lubricating oil must be added to each lubrication part, especially in the worm gear box, which must be filled with 7 gear oil as required. At the same time, in terms of the law of lubricating oil, the lubricating periodic table must be formed according to the requirements of the instructions. Do not use small-diameter bending tools to bend large-diameter steel bars.

7. Before starting work, adjust the bending accuracy according to the bending degree of the steel bar.

8. After the equipment is used for 200 hours, the lubricating oil in the worm gear box should be changed once. Before changing the oil, the tank should be flushed with kerosene.

9. After each use, we must develop a habit of checking. Check whether there is any loosening of screws, whether some parts should be replaced regularly, and make statistics on the parts that have been replaced, so as not to have a more familiar understanding of your own steel bending machine.

10. When the equipment is not used for a long time, anti-rust grease should be applied to the non-painted parts of the machine processing surface and stored in a dry place indoors.